Difference between revisions of "Setting packet connection tracking metainformation"

From nftables wiki
Jump to navigation Jump to search
(→‎helpers: dictionary -> map)
m (link Connection Tracking System; grammar)
Line 1: Line 1:
You can set some bits of the packet conntrack metainformation, apart of [[Matching connection tracking stateful metainformation | matching on it]].
You can set some bits of the packet [[Connection_Tracking_System | conntrack]] metainformation, as well as [[Matching connection tracking stateful metainformation | match on it]].


== notrack ==
== notrack ==

Revision as of 11:14, 15 February 2021

You can set some bits of the packet conntrack metainformation, as well as match on it.

notrack

You can use the notrack support to explicitly skip connection tracking for matching packets.

The example below skips traffic for 80/tcp and 443/tcp:

nft add rule ip raw prerouting tcp dport { 80, 443 } notrack

Please, note that you should use notrack before the kernel connection tracking is triggered. Use a chain with priority -300. Example:

nft add table raw
nft add chain raw prerouting { type filter hook prerouting priority -300 \; }
nft add rule raw prerouting tcp dport 80 notrack

Support for this was added in linux kernel 4.9 and in nftables v0.7.

helpers

You can assign each packet a conntrack helper.

Instantiate a helper, using a named object:

table filter {
      ct helper sip-5060 {
             type "sip" protocol udp;
      }

      ct helper tftp-69 {
             type "tftp" protocol udp;
      }

      ct helper ftp-standard {
             type "ftp" protocol tcp;
      }

      chain c {
             type filter hook prerouting priority 0;
      }
}

Your chain priority must be > -200, because conntrack registers at this priority. Otherwise, packets will not find any conntrack information (which is required to attach the helper).

Then, from the rules:

nft add rule filter c ct state new tcp dport 21 ct helper set "ftp-standard"
nft add rule filter c ct state new udp dport 5060 ct helper set "sip-5060"
nft add rule filter c ct state new udp dport 69 ct helper set "tftp-69"

You can use a map to assign many helpers using a single rule:

nft add rule filter c ct state new ct helper set ip protocol . th dport map { \
                        udp . 69 : "tftp-69", \
                        udp . 5060 : "sip-5060", \
                        tcp . 21 : "ftp-standard" }

which sets the helper based in the transport protocol number and the transport destination port.

You need nftables >= 0.8 and the kernel >= 4.12 to use this feature.

In case of a previous version of nftables, you can enable automatic assignment with:

echo 1 > /proc/sys/net/netfilter/nf_conntrack_helper

Also, with the sysctl parameter:

net.netfilter.nf_conntrack_helper = 1